XTHERM CONDENSING WATER HEATERS, 1005A-2005A

Description

The proven XTherm – vertical modulating condensing heater in sizes to 2000MBTU. XTherm combines time-honored high-recovery copper fin technology with cutting edge control and combustion advancements. The installer and building owner enjoy broad installation flexibility, easy commissioning, and long term reliability.

 

 

Features:

⦁ 97% efficiency. Condensing, Cat IV venting required.

⦁ Brass headers and pumps with copper finned-tube primary heat exchanger. Cupro-nickel tubes available as options. CSA Low Lead Certified 0.25% lead

⦁ Minimum continuous inlet water temperature (50°F)

⦁ On/Off firing with soft-start ignition

⦁ Small footprint, less than 11 square feet

⦁ On-board diagnostic center, real English, no codes

⦁ All models indoor/outdoor construction

⦁ Complete cabinet protects all controls and wiring

⦁ Certified under SCAQMD rule 1146.2. Meets all Low NOx regulations.

⦁ Suitable for altitudes up to 10,000 ft. (derate above 5,000 ft.)

⦁ Primary-secondary piping required.

⦁ 0-10 VDC Remote set-point BMS Interface

⦁ 0-10 VDC Direct Drive

⦁ Available for natural gas or propane.

⦁ VERSA IC® control package.

⦁ Cascade control of up to 8 units, no external sequencer required.

⦁ Modbus® RTU port (RS485).

Options:

⦁ BACNet IP, BACnet MS/TP, Modbus TCP, N2 Metasys (B-85)

⦁ Lonworks (B-86)

⦁ Centrotherm® Polypropylene Vent Adapter (D-33)

⦁ Alarm with 4” Bell (E-5)

⦁ Low Water Cutoff (F-10)

⦁ Condensate Neutralizer (Z-12)

⦁ PVC Vent (Factory-Installed ONLY) (D-32)